wiki rev 1.1, 24/10/2024
Step 0 :
Start your mount and home it ! After FW update we will loose the home position.
Step 1 : Remove 4 hex in the RED location do not remove the BLUE ones
Step 2 : Remove the 4 bigger hex screw in the RED locations
Step3 : The front plate is tighly pressed onto the case, we will place a small screwdriver here to exerce some force directed to the top to left the top cover and remove it :
Step 4 : Label all connected cables to remember how they were placed :
Step 5 : Adjust the selectors to enable FLASHING of the new firmware :
Initial state : to use the mount
X. X
X. X. X. X.
1 2. 3. 4. 5. 6.
To upgrade Onstep : position 4 has to go UP
X. X. X
X. X. X.
1 2. 3. 4. 5. 6.
Step 6 : On you Windows PC :
Install drivers : https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers?tab=downloads You need :
CP210x VCP Windows CP210x Windows Drivers
Download firmware :